The keypad, see figure 2, can be used to set all parameters of the frequency regulators. The keypad must first be put in the ‘ALL USER menu’.

A: Function keys
B: Status
C: Bar graph
D: Function list 1
E: Function list 2
F: Parameter set
G: Code number
H: Sub-code number
I: Parameter contents with unit


Take the following steps to put the keypad in the ‘ALL USER menu’:
1 Connect the keypad (see figure 1, ).
2 Switch on the current of the frequency regulator (see figure 1, ); after a few seconds, the message shown in figure 1,  will appear on the display.
3 Press (1<=>2) ; ‘1’ will appear on the display.
4 Press (=>); ‘USER’ will appear on the display.
5 Press (up); ‘ALL’ will appear on the display.
 Press (<=>) ; the display will revert to the original situation.

The parameters can now be changed.
The second line of the display, see figure 2 arrow D, is important here.

Take the following steps to change the parameters:
 At this moment ‘Disp’ is framed. Press => ; ‘Code’ is now framed.
 Use (up) or (down) to go to the code (parameter) that is to be changed.
 Press => at the desired code.
Some codes have a sub-code. If this is the case, then ‘Subcode’ will be framed.
 Use (up) or (down) to go to the desired sub-code.
 Press => at the desired sub-code.
 ‘Para’ is now framed.
 ‘Para’ is now framed.
 Press (up) or (down) to enter the desired value.
 Press (enter) to confirm the desired value.


 Press (down) to decrease the value of Code ‘140’ to 0.00 Hz; the motor will stop running.
 Press (up) to put the value of Code ‘1511’ back to ‘17’.